top of page

DATA SHEET

  • Surface should be free from any loose paint, dust or grease. Growths of fungus, algae or moss should be removed by wire brushing and water.

 

  • In case of dents and holes use Ocean Acrylic Wall Putty or white cement and fine sand in the ratio 1:3.

 

  • Sand the surface with sandpaper and wipe clean.

 

  • Dilute and apply Ocean Interior wall primer in the ratio of 1:1 (i.e 1 kg of primer with 1 ltr of water). Recoat if necessary after 3-4 hours depending on the surface.

DIRECTIONS OF USE

COVERAGE CAPACITY:

COATS

AREA

2 COATS ON

NORMAL MASONARY

SURFACE

55 - 60 Sq.ft/ltr.*

Precautions:

  • Do not apply when ambient temperature is less than 10°C or if the temperature might drop to this level within 4 hrs of application.

  • Do not over-thin or over-extend the brush.

 *Actual Coverage may vary from the quoted coverage due to factors such 

  as method and mode of application and surface roughness and porosity. 

 TECHNICAL DATA :

        Drying time                                         Surface dry time 30 min

 

        Sheen levels                                        15-35 at 35 deg GH

 

        Stability of thinned paint                  To be used within 24 hours    

 

        Coverage                                             On smooth masonary surface, 1 coat = 215 to 240 sq ft/ltr

 

SAFETY HAZARDS:

SAFETY HAZARDS:

  • Store the container with the lid tightly closed in an upright position, in a cool, dry place.

 

Keep out of reach of children and away from eatables.

 

May be harmful if swallowed. In case of ingestion seek immediate medical attention. Wear eye protection during application. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. In case of skin contact immediately wash skin with soap and plenty of water. Get medical attention if irritation develops or persists.

 

Do not breathe vapour or spray.It is recommended to wear suitable nose pad during sanding and surface preparation to avoid dust inhalation.

 

Do not pour leftover paint down the drain or in water courses. In the event of spills, contain spillage using sand or earth. No added Lead, Mercury or Chromium compounds.

 (Information in this leaflet is given in good faith, but without warranty)

bottom of page