DATA SHEET
-
PLASTER: New masonary surfaces must be allowed to cure completely. It is recommended to allow 28 days as the curing time for new masonary surfaces.
-
CLEANING: Surface should be free from any loose paint, dust or grease. Growths of fungus, algae or moss should be removed by
-
wire brushing and water.
-
FILLING FOR HOLES & DENTS: In case of dents and holes use Ocean Acrylic Wall Putty or white cement and fine sand in the ratio 1:3.
DIRECTIONS OF USE
COVERAGE CAPACITY:
COATS
AREA
On Primed masonary surface with putty knife
1 coat
2 coat
30 - 42 Sq.ft/kg.*
20 - 32 Sq.ft/kg.*
*Actual coverage may vary depending upon the surface and its preparation*
TECHNICAL DATA :
Drying time Surface dry time ~ 30 minutes max
** Practical spreading Rate will vary from the quoted Theoretical Spreading Rate due to factors such as method and condition of application and surface roughness.**
TECHNICAL DATA :
SAFETY MEASURES :
PRECAUTIONS:
-
This product is flammable.
-
Do not apply when the ambient temperature is less than 10°C or if the temperature might drop to this level within 4 hours of application.
-
Work in a well-ventilated place. Wear protective clothing like overalls and gloves. Store the product at ambient conditions in well-ventilated locations and away from the source of ignition and fire.
-
Do not over-thin or overextend the brush.
-
Avoid eye and skin contact. In case of eye and skin contact wash with plenty of clean water. Do not inhale or inject. In case of inhalation move to fresh air. Seek medical attention if symptoms persist in both the cases.
-
Use protective equipment like rubber/polythene gloves, safety goggles/glasses and face mask while handling the paint. In case if settling is noticed, homogenize the material by mixing and use
-
Store the container with the lid tightly closed in an upright position, in a cool, dry place.
-
Keep out of reach of children and away from eatables.
-
May be harmful if swallowed. In case of ingestion seek immediate medical attention.
-
Wear eye protection during application. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. In case of skin contact immediately wash skin with soap and plenty of water. Get medical attention if irritation develops or persists.
-
Do not breathe vapour or spray.It is recommended to wear suitable nose pad during sanding and surface preparation to avoid dust inhalation.
-
Do not pour leftover paint down the drain or in watercourses. In the event of spills, contain spillage using sand or earth.