DATA SHEET
-
PLASTER: New masonary surfaces must be allowed to cure completely. It is recommended to allow 28 days as the curing time for new masonary surfaces.
-
CLEANING: Surface should be free from any loose paint, dust or grease. Growths of fungus, algae or moss should be removed by
-
wire brushing and water.
-
FILLING FOR HOLES & DENTS: In case of dents and holes use Ocean Acrylic Wall Putty or white cement and fine sand in the ratio 1:3.
DIRECTIONS OF USE
COVERAGE CAPACITY:
COATS
AREA
On Primed masonary surface with putty knife
1 coat
2 coat
30 - 42 Sq.ft/kg.*
20 - 32 Sq.ft/kg.*
*Actual coverage may vary depending upon the surface and its preparation*
TECHNICAL DATA :
PRECAUTIONS:
-
Do not apply when the ambient temperature is less than 10°C or if the temperature might drop to this level within 4 hrs of application.
-
Do not over-thin or over-extend the brush. Tinted paints need thorough shaking immediately after tinter addition as well as before use.
Drying time Surface dry time 30 mins.
Sheen Levels 15-35 at 35 deg GH
Stability of thinned paint To be used within 24 hours.
TECHNICAL DATA :
SAFETY MEASURES :
-
Store the container with the lid tightly closed in an upright position, in a cool, dry place.
-
Keep out of reach of children and away from eatables.
-
May be harmful if swallowed. In case of ingestion seek immediate medical attention.
-
Wear eye protection during application. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. In case of skin contact immediately wash skin with soap and plenty of water. Get medical attention if irritation develops or persists.
-
Do not breathe vapour or spray.It is recommended to wear suitable nose pad during sanding and surface preparation to avoid dust inhalation.
-
Do not pour leftover paint down the drain or in watercourses. In the event of spills, contain spillage using sand or earth.