DATA SHEET

 

  • ​​To obtain optimum results, the surface should be cleaned thoroughly and must be free from moisture, dust, dirt, grease, rust and loose/flaking particles.

 

  • On ferrous metal surfaces, a coat of Zinc-Chromate/ Red Oxide Metal Primer is recommended. On Cement plaster surface, a coat of Ocean Cement Primer (oil based) is recommended.

 

  • For better and durable finish, first apply one coat of Ocean Synthetic Enamel on a primed surface. Allow it to hard dry before applying the second coat. To obtain brushing or spraying consistency, use good quality GP thinner

 

  • For better results, it is advisable to apply two coats of Ocean Synthetic Enamel giving 6-8 hours of drying time between the coats. The first coat should be sanded with water proof emery paper, before the second coat is applied.

 

  • Stir well before use

DIRECTIONS OF USE

COVERAGE CAPACITY:

COATS

AREA

2 COATS ON

SMOOTH NON - ABSORBENT 

SURFACE

90 - 100 Sq.ft/ltr.*

 *Actual Coverage may vary from the quoted coverage due to factors such 

  as method and mode of application and surface roughness and porosity. 

  PRECAUTIONS:

  • Tinting must be done, if required, before thinning.

  • Do not over thin.

  • Stir well and strain before use.

 TECHNICAL DATA :

  Areas of application                              Metals, plaster, masonry and other surfaces

 

  Viscosity of Supply                               For white 120 ± 10 secs by Ford Cup B4 at 30 ◦C

 

 Thinner recommended                        Good quality general purpose thinner

 

 Recommended Appl Viscosity           Brushing 60 ± 5 secs by Ford Cup B4

                                                               Spraying  45 ± 5 secs by Ford Cup B4 at pressure 3-3.5kg/cm2

 

  Recommended Primers                      For  Metals-  Ocean Red Oxide Metal Primer

                                                               For  walls and plasters – Ocean Knifing Paste Filler to fill up

                                                                                                         Dents & surface imperfection, Ocean

                                                                                                         Cement primer (oil based)

 

  Method of Application                     Ocean Synthetic Enamel can be applied by brush, spray or roller

 

  Drying time (@28-30◦C)                 Tack free- not more than 6 hrs, Hard dry- not more than 18 hrs

 

  Finish                                                 Smooth & Glossy

 

  Flash Point (Abel’s closed cup)      Above 30◦C (86◦F)

 

  Shades Available                              As per shade card

FIRE HAZARD CLASS

Flammable

 

 SAFETY MEASURES

Recommended to wear protective

clothing like gloves, overall, etc.

 (Information in this leaflet is given in good faith, but without warranty)