top of page

DATA SHEET

 

   Directions for use :

 

  • Remove loose plaster and dust particles and rub lightly with sand paper. Previous coatings of limewash, colour wash and powder distemper must be scraped off

 

  • In case of repainting earlier coating of oil based or emulsion based paints need to be removed if in sound condition. However, the sheen on such surfaces must be removed by thorough sanding. Cracked or flaking paint must be scrapped off completely and the surface should be clean and dry before application of paint.

 

  • Apply a coat of Ocean water based cement primer where necessary. For best results, fill up dents with 2 or more coats of Ocean Acrylic Putty in thin layers. Wherever putty is applied, a coat of Ocean cement primer is recommended as an undercoat on the top of  the putty for eliminating the patchy appearance in the final coats. 

 

  • Ocean Acrylic Distemper is supplied as a thick paste and water is to be added slowly to the paste while stirring to obtain brushing consistency. Normally, for thinning, add 750 ml of clean portable water to 1 kg of Acrylic Distemper. However the amount of water needed will depend upon the porosity and texture of the substrate. Apply 2-3 coats by brushing, keeping an inter-coat interval of about 4 hours between successive coats.

DIRECTIONS OF USE

COVERAGE CAPACITY:

COATS

AREA

1 coat                       120 - 140 sq.ft/kg**

 

2coats                        80 - 110 sq.ft/kg**

 *Actual Coverage may vary from the quoted coverage due to factors such 

  as method and mode of application and surface roughness and porosity. 

  PRECAUTIONS:

  • Tinting must be done, if required, before thinning.

  • Do not over thin.

  • Stir well and strain before use.

 TECHNICAL DATA :

       Areas of application                     Interior plasters, brick work, asbestos, etc

 

       Consistency offered                    290-320 divisions on Penetrometer

 

       Recommended Thinner               Clean portable water

 

       Dilution                                         Add 750 ml of water to 1 kg of Distemper

 

       Method of Application                Brush , Roller

 

       Primer Recommended                 Ocean Water Base Primer

 

       Drying Time (@28-30◦ C)            Surface dry in 15 to 20 minutes

 

       Recoating                                       After an interval of 4 hours

 

       Finish                                              Smooth and Egg- Shell sheen

 

      Shades available                             As per shade card

FIRE HAZARD CLASS

Non- flammable

 

 SAFETY MEASURES

Recommended to wear protective

clothing like gloves, overall, etc.

 (Information in this leaflet is given in good faith, but without warranty)

bottom of page